AP8030 Air Purifier With True HEPA-13 Filter

The Pre FIlter is responsible for capturing initial dust and allergen particles.

This filter captures dust, smoke, pollen and other allergens.

This filter removes odours from the air.

• All packaging from the Air Purifier should be removed and discarded, before assembling and powering on. • Ensure any packaging is removed from the filter before it is installed in the Air Purifier and powered on. • Select a suitable flat location and environment for the unit to be setup. • For proper air flow, locate the unit at least 20cm away from walls and fixtures, to ensure adequate air intake. • Check and confirm there is no blockage to air intake. • Once the above has been checked, the Air Purifier is OK to be plugged into mains power, and switched on. See below operating instructions.

POWER button: Press this button to switch the unit ON/OFF. Note: Press and hold POWER Button for 5 seconds to reset the Filter Reset indicator. IMPORTANT: Always set the Air Purifier down gently on a flat and level surface. When moving the Air Purifier, always lift using two hands.   TIMER button: 1) By pressing this button, the purifier can be timed to operate for intervals of 2 hours, 4 hours and 8 hours, stopping automatically when the selected operating time has elapsed. 2) Press the (TIMER) button to select the required operating time. A light automatically indicates the operating time duration selected. 3) To select the continuous operating mode, press the button repeatedly until there are no more indicator lights lit up LIGHT/SLEEP button: 1) Press this button one time to turn on the night light. 2) Press this button twice to turn on Sleep mode. The indicator flickers before all indicators dim and air purifier will turn to low speed automatically. 3) Press this button three times to turn off the night light. 4) Press this button four times to turn off the sleep model & night light. SPEED button: The fan speed can be adjusted when the Air Purifier is in operation (L/I M/II H/III Turbo/IV). Each time that you press the (SPEED) button, the speed is adjusted from L (Low) to M (Medium) to H (High) to TB (Turbo). When in sleep mode, press any button to activate the machine, and sleep mode will turn off. IMPORTANT: When the unit is not in use, switch it off and unplug it.

When the FILTER RESET light switches on in red continuously, this indicates that it is time to replace the filter. Replace the filter according to the directions below, then press the POWER button holding for 5 seconds to reset the filter indicator. The FILTER RESET light will then turn off. *True HEPA Filter life is approximately 6 months. 1. Turn off and unplug the Air purifier, turn the air purifier upside down. 2. Remove the screw from the base then twist the base to open. 3. Remove the dirty filter and insert the new filter into the Air Purifier. 4. Reattach the base to the unit and secure it with the screw. Note: If the filter is not in place or not fitted correctly the Air purifier will not operate.